2004 Iveco Daily 35C15 Mwb

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Bumper insecure (6.1.4 (a) (i))

Nearside Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Rear Bumper likely to become detached (6.1.4 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Battery tray corroded

Underneath of vehicle corroded and holed outside prescribed areas

Windscreen damaged but not adversely affecting driver's view Chipped (3.2 (a) (i))

Front sub frame has slight corrosion

Park brake has only just met the requirements

Steel brake pipes have areas of slight corrosion

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside marker

clutch pedal rubber missing

Nearside Rear brake disc contaminated by oil (3.5.1h)

Offside Rear brake disc contaminated by oil (3.5.1h)

Offside Rear Leaf spring to axle securing bolt insecure (2.4.B.7b)

o/s and n/s rear hunb seals leaking

rear back plates corroded

Battery insecure (1.9.1)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front front brake binding (3.7.B.1)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

front brake application uneven (3.7.B.2)

rear brake application uneven (3.7.B.2)

o/s and n/s rear hunb seals leaking

rear back plates corroded

Brake load sensing valve linkage obviously incorrectly adjusted (3.6.E.3)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside rear brake recording little or no effort (3.7.B.5a)

front brake application uneven (3.7.B.2)

Battery insecure

Battery insecure

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Brake load sensing valve linkage stiff (3.6.E.3)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Brake load sensing valve linkage stiff (3.6.E.3)

Offside Headlamp aim too low and too far to the left. (1.8)

Nearside Front Upper Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)