2004 Mazda Bongo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front wipers poor condition

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassi (5.3.6 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassi (5.3.6 (a) (i))

high level stop light not working

under side corroded

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Cross member (6.2.2 (d) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Headlamp lens slightly defective Cracked at bottom (4.1.1 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Steering wheel modified

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Cross member (6.2.2 (d) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Headlamp lens slightly defective Cracked at bottom (4.1.1 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Steering wheel modified

Brake pipe excessively corroded front to rear (1.1.11 (c))

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Rear Exhaust system insecure (6.1.2 (a))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Rear Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

general corrosion and holes to rear underside of vehicle

Horn not working (7.7 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner /outer sill (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front slight play track rod end

Nearside Front Suspension component mounting prescribed area is excessively corroded under step (2.4.A.3)

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded under step (2.4.A.3)

Rear Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Registration plate lamp not working both (1.1.C.1d)

Offside Front slight play track rod end

Items removed from driver's view prior to test ()

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Ball joint has excessive play (2.2.B.1f)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Items removed from driver's view prior to test ()

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Anti-roll bar ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Anti-roll bar ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Both front outer sills bent

Brake pipes coated in grease/sealant

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Fuel system component leaking (7.2.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Registration plate lamp not working (1.1.C.1d)

Battery insecure

Coolant leak

Nearside Headlamp aim too low (1.8)

Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

offside rear inner wheel arch holed but outside prescribed area

Nearside Front Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Offside Front Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Offside Front Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

offside rear inner wheel arch holed but outside prescribed area

Nearside Side repeater not working (1.4.A.2c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Headlamp aim too high (1.8)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust has part of the system excessively deteriorated (7.1.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

O/S and N/S front c.v boots o.k at time of test.

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)