2005 Mazda Bongo Friendee

Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill (6.1.1 (c) (i))

Nearside Rear Body panel corroded and likely to cause injury Outer sill (6.2.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced Inner wing (6.1.1 (c) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced Inner sill area (6.1.1 (c) (i))

o/s and n/s rear inner wheel arch corroded

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill door step (6.1.1 (c) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

o/s and n/s rear inner wheel arch corroded

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill corroded and holed in 2 places (6.1.1 (c) (i))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill corroded and holed in 2 places (6.1.1 (c) (i))

Nearside Front Windscreen wiper blade defective small split on blade (3.4 (b) (i))

Nearside Front box section holed (strengh not affected )

Offside Front Outer sill weak

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill holed in 2 places (6.1.1 (c) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch holed (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill holed in 2 places (6.1.1 (c) (i))

under side repairs covered in under seal

Nearside Front Brake prescribed area is excessively corroded flexi pipe mounting prescribed area (1.1.21 (e) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength front crossmember (5.3.6 (a) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch/bumper mounting (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength front crossmember (5.3.6 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch/bumper mounting (6.1.1 (c) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure cords visible in cracks (5.2.3 (d) (ii)) DANGEROUS

Front radiator cross member corroded and holed

Nearside Front Outer sill slightly corroded and holed

exhaust system has small blow (2 boxes)

under body corrosion to axles and members

Front chassis cross member corroded and holed

Nearside Rear spring upper mounting corroded

Nearside Front Battery insecure (1.9.1)

Nearside Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Rear passenger door cannot be opened from outside the vehicle (6.2.B.1c)

Offside Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Brake lining(s) less than 1.5 mm thick lining worn down to metal backing (3.5.1g) DANGEROUS

Front chassis cross member corroded and holed

Nearside Rear spring upper mounting corroded

Nearside Front Battery insecure (1.9.1)

Nearside Front Lower Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front brakle discs coroded and pitted on inner faces

front radiator cross-member coroded

front windscreen damaged in wiper sweep

n/s front inner sill coroded

o/s outer sill coroded and holed

front and rear brake discs pitted on inner face

small windscreen damage in zone (A)

Nearside Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Lower Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Offside Front Lower Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Lower Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

front and rear brake discs pitted on inner face

small windscreen damage in zone (A)

Nearside Registration plate lamp not working (1.1.C.1d)

advise front brake discs scorde /corroded

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Offside Rear Tie bar/rod attachment bracket/mounting damaged and its strength is seriously reduced (2.4.G.1)