1995 Mazda Bongo

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Vehicle structure excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive out rigger (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive out rigger (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake pressure storage reservoir has minor damage cap missing from brake fluid reservoir (1.1.9 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis leg (6.1.1 (c) (i))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Sub-frame corroded and seriously weakened cross member/radiator support (5.3.3 (b) (i))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength mcpherson strut mounting area (5.3.6 (a) (i))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Offside and nearside inner sills excessively corroded (6.1.1 (c) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis leg (6.1.1 (c) (i))

Rear Brake pad(s) wearing thin wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch 2 locations (5.3.6 (a) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting cross member by front wheel arch underneath (6.2.2 (d) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired inner sill (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases back box and joint (6.1.2 (a))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front body corroded inner front wheel arch

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front body corroded inner front wheel arch

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Wheel arch corroding.

Nearside Rear Outer Sill starting to corrode.

Offside Rear Chassis rail corroding.

Oil leak, but not excessive (8.4.1 (a) (i))

Slight exhaust blow on rear joint.

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake disc contaminated (1.1.14 (b))

Rear Seat belt missing center lap belt (7.1.2 (a))

Rear Seat belt missing rear centre lap belt (7.1.2 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Nail in tyre ()

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

corrosion to front chassis

front subframe corroded

front to rear heater matrix pipes corroded

fuel pump seals leaking

oil residue around turbo hose

rear brake discs appear to have overheated at some point

Front Vehicle structure has slight corrosion (6.1.A.1)

Offside Front Shock absorber has slight external damage to the casing (2.7.2a)

Vehicle structure has slight corrosion (6.1.A.1)

centre exhaust section corroding and leaking.

front chassis under radiator corroding.

nearside and offside doorsils and inner sils corroding.

rear tyres wearing near limit on edges.

Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) has restricted free movement (3.5.1k)

centre exhaust section corroding and leaking.

front chassis under radiator corroding.

nearside and offside doorsils and inner sils corroding.

rear tyres wearing near limit on edges.

Nearside Front Anti-roll bar linkage worn and seriously weakened (2.4.G.1)

Nearside Inner Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage worn and seriously weakened (2.4.G.1)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Inner Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Front Direction indicators incorrect colour (1.4.A.2f)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.C.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside front inner sill holed but not within prescribed area.

Power steering component(s) has slight seepage from a component (2.3.3b)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.C.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Advise both front tyres are going out of shape

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front brake disc excessively pitted (3.5.1h)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

OFFSIDE OUTER SILL AND BOTH INNER SILLS STARTING TO CORRODE

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)