1996 Mazda Bongo

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wheel arch (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Flitch (5.3.6 (a) (i))

Offside Front Power steering component leaking (2.1.5 (a))

Offside Front Seat belt webbing significantly weakened cut from edge greater than 2mm (7.1.2 (b))

Offside Rear Oil leaking excessively from transmission Hub seal (8.4.1 (a) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases Exhaust flex section (6.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

adise vehicle had many welding repairs

Offside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Horn not working (7.7 (a))

Offside Front Lower Suspension arm attachment bracket/mounting insecure nut loose (5.3.3 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Offside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Lower Suspension arm ball joint excessively worn both (5.3.4 (a) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill marked chalk (6.1.1 (c) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill marked with chalk (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch (6.2.2 (d) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

both front head lights dulled

Nearside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

offside rear hub seal corroded

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded sill to floor (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill to floor (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

nearside front sill to floor corroded but not within prescribed area

nearside sill corroded but not within prescribed area

offside front sill to floor corroded but not within prescribed area

offside rear hub seal corroded

offside sill corroded but not witin prescribed area

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Rear Exhaust has a minor leak of exhaust gases flange (7.1.2)

both inner and outer sills corroded and holed but greater than 30cm from any mounts

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Rear Exhaust has a minor leak of exhaust gases flange (7.1.2)

both inner and outer sills corroded and holed but greater than 30cm from any mounts

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

nearside steering rack boot twisted

offside sill corroded but not within pescribed area

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

nearside steering rack boot twisted

offside sill corroded but not within pescribed area

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Front Lower Power steering ram(s) leaking from a failed component (2.3.3b)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Front Headlamp aim too high and too far to the right. (1.8)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Lower Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Offside Rear Stop lamp not working (1.2.1b)

Service brake: efficiency below requirements (3.7.B.7)

Rear load space seat belts and seat security not tested. Front tyres worn to 3.5 mm approx. All brake pipes starting to pit in surface.

oil leak on steering rack damp

oil leak under engine damp

Nearside rear brake juddering slightly (3.7.A.5b)

Offside rear brake juddering slightly (3.7.A.5b)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Offside Stop lamp not working (1.2.1b)

Centre Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Power steering component(s) leaking (2.3.3b)

Rear fog lamp emits a light other than red (1.3.2e)

Nearside rear brake juddering slightly (3.7.A.5b)

Offside rear brake juddering slightly (3.7.A.5b)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)