1995 Mazda Bongo

Central Front Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings cross member. heavily corroded holed by lower radiator mount (6.1.B.2)

Central Rear Statutory seat belt missing (5.1.1)

Nearside Body has a sharp edge caused by corrosion sill corroded holed B piller area (6.1.C.1)

Nearside Front Battery insecure (1.9.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill corroded/holed that bad, that rear wheel arch to rear panel all included (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Battery insecure (1.9.1)

Offside Front Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre has ply or cords exposed side wall. inner shoulder worn, punctured to (4.1.D.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded osr sill corroded. even wheel arch to rear panel heavily corroded from that point (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Statutory seat belt missing middle row, near side stalk missing (5.1.1)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear bumper insecure. no panel left to secure it

Offside Rear bumper insecure. no rear panel left to secure it to.

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings INNER (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings OUTER (6.1.B.2)

Fuel system component leaking fuel pump (7.2.3)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Rear nail in tyre

Offside Inner Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

front crossmember corroded

Nearside Front Lower Anti-roll bar insecure (2.4.G.1)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Inner Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

front crossmember corroded

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Oil leak

both sides front floor to sill areas rusted through out of prescribed area

front and rear brake pipes covered in grease

offside wiper small

outersill areas corroded and repaired

Fuel system component leaking (7.2.3)

Nearside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

o/s/f brake disk corroded on inner edge

slight corrosion to n/s outer sill

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Seat belt stitching badly frayed (5.2.2b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

o/s/f brake disk corroded on inner edge

slight corrosion to n/s outer sill

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)