2004 Mitsubishi Delcia

EMISSIONS TOO CLEAN TO REGISTER

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Brake performance unable to be tested due too n/s front brake jammed on (1.2.1 (g))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Offside Front Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened both rears (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material all steel pipes (1.1.11 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front nut missing of exhaust flange.

Front under tray insecure.

Hazard warning switch insecure (4.4.2 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Exhaust silencer insecure clamp missing. (8.1.1 (b) (i))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Front nut missing of exhaust flange.

Front under tray insecure.

Hazard warning switch insecure (4.4.2 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Bolt missing from front pipe flange

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside front brake binding (3.7.B.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front Steering component mounting prescribed area is fractured (2.2.C.1h)

Nearside Inner Ball joint has excessive play (2.2.B.1f)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Inner Ball joint has excessive play (2.2.B.1f)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear fog lamp not working (1.3.2b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Emissions not tested (7.0)

Fuel system component leaking (7.2.3)

Nearside Front Front position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Anti-roll bar synthetic bush deteriorated resulting in excessive movement (2.4.G.2)

Service brake: efficiency below requirements (3.7.B.7)

Centre Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

oil leak

various brake pipes slighty corroded

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Front Windscreen washer provides insufficient washer liquid (8.2.3)