2006 Mazda Bongo

Nearside Rear Inner Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired valance (6.2.2 (d) (ii)) DANGEROUS

Nearside Rear Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired outer sill (6.2.2 (d) (ii)) DANGEROUS

Offside Inner Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired sill (6.2.2 (d) (ii)) DANGEROUS

Offside Rear Inner Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired valance (6.2.2 (d) (ii)) DANGEROUS

Nearside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Integral body structure inadequately repaired such that structural rigidity is significantly reduced inner sill (6.1.1 (d) (i))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor to inner sill (6.1.1 (c) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting chassis (6.1.6 (i) (i))

Offside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Nearside Rear Nail in tyre ()

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Nail in tyre ()

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Sub-frame ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inside edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge inside edge (5.2.3 (e))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill / Out Rigger (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Front Battery insecure but not likely to fall from carrier x 2 (4.13 (a) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner and outer full sill holed (6.1.1 (c) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear brake fluctuating, but not excessively x 2 (3.7.B.3)

Central Front Subframe mounting prescribed area is excessively corroded cross member (2.4.A.3)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Headlamp aim too low and too far to the right. (1.8)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Rear fog lamp switch missing (1.3.1a)

rear brake fluctuating, but not excessively x 2 (3.7.B.3)

Front front brake fluctuating, but not excessively x2 (3.7.B.3)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front battery tray is corroded

Rear rear brake fluctuating, but not excessively x2 (3.7.B.3)

Front front brake fluctuating, but not excessively x2 (3.7.B.3)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp aim too high (1.8)

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Offside Front battery tray is corroded

Rear rear brake fluctuating, but not excessively x2 (3.7.B.3)

Nearside Rear Vehicle structure has slight corrosion (6.1.A.1)

Nearside Rear wheel arch corroded

Offside front brake fluctuating, but not excessively (3.7.B.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear fog lamp insecure (1.3.2a)

Rear fog lamp not working (1.3.2b)

Electrical wiring insecure (1.9.2a)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Seat belt insecurely fixed to the vehicles structure (5.2.1a)

Rear Seat belt locking mechanism does not secure or release (5.2.5a)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Vehicle structure has slight corrosion (6.1.A.1)

Offside front brake fluctuating, but not excessively (3.7.B.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)