2004 Mazda Bongo

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Outer Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner wheel arch corroded

Offside Rear Suspension component mounting repair covered in underseal chassis (5.3.6 (a) (i))

Rear Suspension component mounting repair covered in underseal chassis (5.3.6 (a) (i))

outer body has been repaired

underside of vehicle has been heavily undersealed

Brake pipe slightly corroded (3.6.B.2c)

Front tyres worn on the edge

Vehicle structure has slight corrosion (6.1.B.2)

body slightly corroded

under body heavily under sealed

Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Vehicle structure has excessive damage seriously affecting its strength within 30cm of a towbar mounting (6.6.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Vehicle structure has excessive damage seriously affecting its strength within 30cm of a towbar mounting (6.6.6)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

underfloor & body corrosion

centre and rear under floor/body areas have corrosion

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner and outer sill holed (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

centre and rear under floor/body areas have corrosion

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Inner Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Vehicle structure has slight corrosion (6.1.A.1)

welding repairs appear satisfactory, however a full visual inspection is not possible due to a coating of seam sealer/underseal

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear position lamp(s) incorrect colour (1.1.A.3e)

Nearside Stop lamp emits other than a steady red light (1.2.1e)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear fog lamp tell tale not working (1.3.1b)

Fuel system component leaking (7.2.3)

both front tyres wearing on outer edges of tread

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

front brake juddering slightly (3.7.A.2b)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brake juddering slightly (3.7.A.2b)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Rear fog lamp not working (1.3.2b)

Offside Windscreen wiper blade deteriorated (8.2.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)