1996 Ducati M600

Motorcycle Drive Chain Has Become Corroded & Dry

Motorcycle structure is corroded but structural rigidity is not significantly reduced Rear Swing Arm (6.1.1 (c) (i))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

wheel bearing slightly rough

Rear Lower Shock absorber has an excessively worn bush (5.3.2 (c))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

wheel bearing slightly rough

Rear Position lamp not working (4.2.1 (a))

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp switch faulty (1.2.4)

Horn not working (1.7.3a)

Nearside Rear Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Nearside Exhaust mounting deteriorated. (7.1.1.c)

Front Front suspension has a slightly reduced damping effect (2.3.6c)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Steering movement slightly 'notchy' (2.2.1a)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Offside Front shock absorber has light misting of stanchion (2.3.3)