2006 Mazda Bongo

Oil leak, but not excessive engine oil leaking (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired sill end (5.3.6 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Towbar excessively corroded within 30cm of towbar mounting behind the bumper (6.1.6 (i) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive outrigger (5.3.6 (a) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Power steering pump has slight seepage (2.1.5 (a))

Rear Prop shaft joint worn, but not excessively rear prop shaft, rear most universal joint (6.1.7 (c) (i))

Central Exhaust has a major leak of exhaust gases middle section (6.1.2 (a))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive outrigger (5.3.6 (a) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Power steering pump has slight seepage (2.1.5 (a))

Rear Prop shaft joint worn, but not excessively rear prop shaft, rear most universal joint (6.1.7 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength crossmenmber (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired sill end panel plate not welded continuously (5.3.6 (a) (i))

Power steering component leaking steering rack top seal (2.1.5 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Body has slight corrosion (6.1.B.2)

Oil leak ()

Rear Brake pad(s) wearing thin unable to fully assess - approx 3mm (3.5.1g)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both sides (2.2.C.1c)

offside rear tyre slightly cracked/perished

rear inner wheel arches corroded - just outside suspension and seat belt prescribed areas

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar synthetic bush deteriorated resulting in excessive movement D bush (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement D bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Oil leak

Nearside Rear Anti-roll bar linkage insecure (2.4.G.1)

Nearside Rear Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Oil leak

Rear Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

o/s/r outer sill corroded but not within a perscribed area

Nearside Front Lower Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Lower Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

o/s/r outer sill corroded but not within a perscribed area

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

offside outer sill corroded

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

offside outer sill corroded

Emissions not tested (7.0)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front position lamp(s) obscured but not more than 50% (1.1.A.3c)