1996 Mazda Eunos

Front Inner Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Lower Vehicle structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Offside Lower Vehicle structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Anti-roll bar has an unsafe modification antiroll bar not center fouling shock absorber (5.3.3 (c) (i))

Nearside Front Brake hose excessively damaged (1.1.12 (b) (ii))

Nearside Front Upper Suspension arm insecurely attached bolt not wound in (5.3.3 (a) (i))

Nearside Front Upper Suspension locking device missing split pin (5.3.6 (b))

Offside Front Upper Suspension locking device missing split pin (5.3.6 (b))

Offside Headlamp aim too low (4.1.2 (a))

Rear Anti-roll bar has an unsafe modification not central very close to nearside shock absorber (5.3.3 (c) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Inner Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Lower Vehicle structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Offside Lower Vehicle structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Shock absorbers insecurely attached (5.3.2 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Front Suspension arm attachment bracket/mounting insecure ball joints not split pinned (5.3.3 (a) (i))

Offside Front Suspension arm attachment bracket/mounting insecure ball joints not secured (split pins ) (5.3.3 (a) (i))

Offside Rear Rear fog lamp light intensity significantly reduced showing white (4.5.4 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Rear Inner sill has slight corrosion

Offside chassis leg [floor] damaged

Exhaust has a minor leak of exhaust gases Centre to rear join (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front registration plate faded but not likely to be misread (6.3.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

front brake pads 4mm

nsf tyre signs of spliting in walls

nsr tyre signs of spliting in walls

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)