1976 MG B

Windscreen washer not working (3.5 (a))

All direction indicators not working (4.4.1 (a) (ii))

Brake lever has insufficient reserve travel (1.1.2 (a))

Brake pipe excessively corroded rear axle pipes (1.1.11 (c))

Front Service brake effort inadequate at a wheel both sides (1.2.1 (a) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength bulk-head to inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner under sill closing panel by spring mounting (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner under sill closing panel by spring mounting (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle off side little or no effort (1.2.1 (b) (i))

Rear Leaf spring seriously weakened both sides excessively corroded and swollen (5.3.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake master cylinder leaking (1.1.10 (b) (ii)) DANGEROUS

Front Coil spring corroded both sides (5.3.1 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both sides tyres perished and splitting (5.2.3 (d) (ii))

bad surface corrosion to vehicle structure in both load bearing and non-load bearing areas