2005 Mazda Bongo

Drive shaft bent drive shaft mount bracket bin hit and bent driveshaft sitting backj (6.1.7 (e))

Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced both inner and outer sills (6.1.1 (c) (i))

Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced rear crossmember (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch (6.1.1 (c) (i))

Offside Front Drive shaft joint excessively worn (6.1.7 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch (6.1.1 (c) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Forward most bush (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D Bush (5.3.4 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D Bush (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material all pipes undersealed not allowing full check (1.1.11 (c))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Nearside Rear bodywork /inner wheel arch badly corroded

Offside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security chassis rail above axle (6.2.2 (d) (i))

Offside Rear bodywork /inner wheel arch badly corroded

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement both mounting bushes (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both discs surface rust /pitting (1.1.14 (a) (ii))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced cross member (6.1.1 (c) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear bodywork /inner wheel arch badly corroded

Brake pipe corroded, covered in grease or other material all pipes undersealed not allowing full check (1.1.11 (c))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Offside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security chassis rail above axle (6.2.2 (d) (i))

Offside Rear bodywork /inner wheel arch badly corroded

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement both mounting bushes (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both discs surface rust /pitting (1.1.14 (a) (ii))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced cross member (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Inner Wheel Arches Heavily Corroded

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Subframe mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded x member behind radiator (2.4.A.3)

Offside Front front brake binding (3.7.B.1)

Offside Rear Subframe mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak ()

Rear Exhaust has a minor leak of exhaust gases silencer (7.1.2)

osr & nsr inner wheel arches heavily corroded

rear chassis bent & rubbing against panhard rod

Offside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Offside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Rear fog lamp not working (1.3.2b)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Body has slight corrosion (6.1.B.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

oil leak

vehicle body sills have corrosion

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Body has slight corrosion (6.1.B.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

oil leak

vehicle body sills have corrosion

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nail in offside front tyre

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

some corrosion to rear crossmember and the rear sections of both rear wheel arch inner tubs

Offside Rear fog lamp not working (1.3.2b)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nail in offside front tyre

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

some corrosion to rear crossmember and the rear sections of both rear wheel arch inner tubs

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp not working (1.3.2b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Oil leak

rust present ..N/S/F...O/S/F...innersills but not corroded...

Brake pad(s) wearing thin (3.5.1g)