2000 Mitsubishi Fto

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside front brake juddering slightly (3.7.A.2b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Stop lamp not working (1.2.1b)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Service brake: efficiency below requirements (3.7.B.7)

4 brake discs corroded

all floors weak

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension has inadequate clearance with the chassis (2.4.A.1a)

Nearside Headlamp aim too high (1.8)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

The rear exhaust mount is attached to the anti roll bar.

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front front brake binding (3.7.B.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

engine very noisy?? /both rear tyres worn too limits

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Vehicle structure has slight corrosion (6.1.A.1)