2012 Abarth 500

Corrosion on rear axle

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Stop lamp(s) emits other than a steady red light (4.3.3 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Corrosion on rear axle

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Brake performance not tested (1.2.1 (g))

Driver's view of the road through the swept area of the windscreen materially affected by an obstruction (3.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Brake pad(s) less than 1.5 mm thick front brake pads (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Shock absorbers insecurely attached (5.3.2 (a) (i))

Nearside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Offside Front Shock absorbers insecurely attached (5.3.2 (a) (i))

Offside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Rear Registration plate inscription illegible (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust noisy (8.1.1 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement bush deteriorated (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement bush deteriorated (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust noisy (8.1.1 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement bush deteriorated (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement bush deteriorated (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too high (1.8)

Both Front Tyres Worn On Inner Edges

Rear Pads Low