2010 Lexus Is F

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both inner sills (6.2.2 (d) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Play in steering rack inner joint(s) ()

Rear Sub-frame pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both inner sills (6.2.2 (d) (i))

Offside Headlamp aim too low (4.1.2 (a))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Play in steering rack inner joint(s) ()

Rear Sub-frame pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Steering rack insecure to the extent there is excessive movement at the mountings (2.1.3 (a) (ii))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear reflector defective or damaged by up to 50% of the reflecting surface nearside (4.8.1 (a) (i))

Position lamp not working offside front (4.2.1 (a))

Tyre has a bulge, caused by separation or partial failure of its structure offside rear (5.2.3 (d) (ii)) DANGEROUS

Rear reflector defective or damaged by up to 50% of the reflecting surface nearside (4.8.1 (a) (i))

Front Brake pad(s) wearing thin (3.5.1g)