1983 Mercedes-benz 240

Offside Front Brake pedal not releasing correctly (1.1.2 (b) (i))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Both sills and rear of underbody covered heavily with sealant

Oil leak, but not excessive (8.4.1 (a) (i))

All wheel arches coated in underseal

Both sills covered heavily with underseal

Offside Rear Inner Drive shaft which forms part of the suspension coupling gaiter deteriorated, but preventing the ingress of dirt (2.4.G.4e)

Rear underbody covered with underseal

extensive welding under flore tochase

extensive welding and corrosion to various areas of vehicle underside

play in nearside front lower balljoint

slight corrosion to both front metal brake pipes

slight play in offside front wheel bearing

both front metal brake pipes starting to corrode

slight play in nearside front lower balljoint

Offside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

both front metal brake pipes starting to corrode

slight play in nearside front lower balljoint

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Fuel pipe leaking (7.2.3)

Horn not working (1.6.2a)

Nearside Front Steering arm has relative movement at its fixings (2.2.B.1h)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Headlamp aim too high (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Direction indicator incomplete (1.5.A1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Brake hose excessively deteriorated (3.6.B.4d) DANGEROUS

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front coil spring incomplete (2.4.C.1a)

Nearside Steering pivot point has excessive play (2.2.B.1g)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)