2002 Piaggio Vespa ET4

Front Lower Motorcycle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Central Inner Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Nail in tyre ()

Central Inner Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Stop lamp not working (4.3.1 (a) (ii))

Rear Nail in tyre ()

Central Lower Motorcycle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Shock absorber has negligible damping effect (5.3.2 (b))

Headlamp aim not tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Brake lever has insufficient reserve travel (1.1.2 (a))

Steering headbearing has slight free play (2.2.2 (f) (i))

Headlamp aim too low (4.1.2 (a))

Steering headbearing has slight free play (2.2.2 (f) (i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e))

Fuel cap missing (6.1.3 (b) (i))

Headlamp aim too high (4.1.2 (a))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake lever has inadequate reserve travel (3.1.3b)

Rear Brake lever has inadequate reserve travel (3.1.3b)

Rear Tyre has a lump caused by separation or partial failure of its structure (4.1.2a(ii))

Rear Tyre worn close to the legal limit (4.1.3(ii))