2005 Honda Cbr

All direction indicators missing all indicators are missing (4.4.1 (a) (ii))

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition silencer is non standard and too loud. (8.1.1 (a))

Headlamp missing (4.1.1 (a) (ii))

Horn not working (7.7 (a) (ii))

Nearside Steering operation fouling on the fuel tank or bodywork on full lock handlebar hits the fuel tank on left lock (2.1.4 (b))

Rear Position lamp not working (4.2.1 (a))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Forks in such a condition that steering control is adversely affected fork brace is missing that is incorporated in the front mudguard. (2.2.2 (d) (ii)) DANGEROUS

Riders seat insecure (6.2.5 (a) (ii)) DANGEROUS

Drive chain slightly loose (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Exhaust slightly loose tail pipe is slightly insecure (6.1.2 (a))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Fuel tank slightly loose (6.1.3 (a) (i))

Nearside Front clutch lever clamp is loose on handlebar

Rear rear suspension damping effect is slightly reduced

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Exhaust noisy (7.1.2)

Front Brake disc(s) slightly scored (3.2.A1l)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Exhaust noisy (7.1.2)

Offside Front Handlebar deformed (2.1.1b)

Clutch slip

Front Brake disc(s) is slightly distorted (3.2.A1m)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Offside front fork tube dust seal damaged

Drive chain excessively loose (6.2.1d)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Clutch slip

Front Brake disc(s) is slightly distorted (3.2.A1m)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Offside front fork tube dust seal damaged

Brake lever is bent but brake can still be readily applied (3.1.3c)

Drive chain excessively loose (6.2.1d)

Headlamp aim too high (1.6)

Rear Floor brake test indicates a binding brake (3.3.C2c)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Brake lever is bent but brake can still be readily applied (3.1.3c)