2007 Piaggio Porter

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Direction indicator not working (4.4.1 (a) (ii))

Front Position lamp not working (4.2.1 (a) (ii))

Hazard warning lamps inoperative (4.4.1 (e))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Nearside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Seat belt buckle damaged (7.1.2 (d))

Offside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Direction indicator not working (4.4.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Fuel tank leaking excessively or a risk of fire (6.1.3 (b) (ii)) DANGEROUS

Front Tyre obviously under inflated (5.2.3 (l))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Tyre obviously under inflated (5.2.3 (l))

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

radiator support bracket badly corroded

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

radiator support bracket badly corroded

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

radiator support bracket badly corroded

Horn not working (1.6.2a)

Nearside Stop lamp not working (1.2.1b)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

radiator support bracket badly corroded

Nearside Headlamp not working on dipped beam (1.7.5a)

Tyre worn close to the legal limit (4.1.E.1)

temp mirror fitted osf