2008 Honda Cb 600 FA-8

Headlamp aim too high (4.1.2 (a))

Chain guard missing ()

Clutch lever perch mounting snapped

Motorcycle structure modified rear

Rear Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Rear Nail in tyre ()

Registration plate incorrect (0.1 (c))

Steering operation fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Chain guard missing ()

Clutch lever perch mounting snapped

Drive chain slightly loose (6.1.7 (c) (i))

Motorcycle structure modified rear

Rear Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Rear Nail in tyre ()

Chain guard missing

Clutch perch mount snapped

Drive chain slightly loose (6.2.1d)

Drive chain sprocket slightly worn (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Motorcycle structure has been slightly modified (6.1.1b)

Nail in rear tyre

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Steering control chaffing between components and not interfering with free movement of steering (2.1.2a)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Motorcycle structure insecure and likely to affect the correct functioning of the steering or braking Number plate holder (6.1.1c)

Rear reflector on motorcycle missing (1.4.1)

Registration plate letter/figure incomplete (6.3.1c)

Riders seat insecure (6.2.1a)

Throttle operating incorrectly (6.2.1f)

Chain guard missing

Clutch perch mount snapped

Drive chain slightly loose (6.2.1d)

Drive chain sprocket slightly worn (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Motorcycle structure has been slightly modified (6.1.1b)

Nail in rear tyre

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Steering control chaffing between components and not interfering with free movement of steering (2.1.2a)

Brake pedal is bent but brake can still be readily applied (3.1.3c)

Chain guard missing

Clutch lever mount cracked

Indicator switch insecure (1.5.4)

Locking devices not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Nearside Front Brake locking device insecure (3.2.A1e)

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Rear Brake pipe inadequately supported (3.2.B2b)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Brake pedal is bent but brake can still be readily applied (3.1.3c)

Drive chain slightly tight (6.2.1d)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive chain slightly tight (6.2.1d)