2007 Honda Ses 125-4

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Slight oil leak

Throttle slightly binding

Headlamp aim too high (4.1.2 (a))

Rear Brake grabbing severely (1.2.1 (c))

Rear Stop lamp remains on when the brakes are released Lever does not return (4.3.2 (a) (iii)) DANGEROUS

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake master cylinder slightly loose (1.1.10 (c))

Rear reflector obviously incorrectly positioned (4.8.2 (a) (i))

Registration plate slightly loose (0.1 (a))

Slight oil leak

Throttle slightly binding

Front Tyre worn close to the legal limit (5.2.3 (e))

Rear Brake indicates a slightly grabbing brake (1.2.1 (c))

Front Tyre worn close to the legal limit (5.2.3 (e))

Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Rear Brake indicates a slightly grabbing brake (1.2.1 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Front Tyre worn close to the legal limit (5.2.3 (e))

apron fitted

brae lamp switches poor in operation

front brake disc is badly worn

Exhaust mounting missing (7.1.1c)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too high (1.6)

Front Brake fluid reservoir fluid level dangerously low (3.2.B1d)

Front Floor brake test indicates a binding brake (3.3.C2c)

Front wheel bearings are excessively rough cant test as front brake binding (2.3.5b)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Stop lamp insecure (1.3.3b)

top box/grab rail bolt missing but not insecure

Front Brake disc(s) slightly scored (3.2.A1l)

Front Front shock absorber has light misting of stanchion (2.3.3)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Brake disc(s) slightly scored (3.2.A1l)

Front Front shock absorber has light misting of stanchion (2.3.3)

Rear Fairings insecure but not likely to impede the steering (2.1.2e)

some shallow crcking in rear tyre been ridden when flat or low pressure

Front Throttle operating incorrectly (6.2.1f)

Front Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Rear Fairings insecure but not likely to impede the steering (2.1.2e)

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

some shallow crcking in rear tyre been ridden when flat or low pressure

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))