2007 Yamaha XT 125 X

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Headlamp aim projected beam image obviously incorrect (4.1.2 (c))

Rear Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Stop lamp does not illuminate by the operation of both brake controls ADJUSTED FRONT BRAKE LIGHT SWITCH (4.3.2 (a) (iii))

Headlamp aim too low (4.1.2 (a))

Brake lever is damaged but the brake can still be readily applied (3.1.3c)

Clutch lever shortened. (6.2.1g)

Exhaust slightly deteriorated (7.1.1a)

Front tyre is cracked

Rear Drive chain sprocket slightly worn (6.2.1e)

Central Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim headlamp deteriorated and function impaired (1.2.3a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i))

Rear reflector on motorcycle missing (1.4.1)

Brake lever is damaged but the brake can still be readily applied (3.1.3c)

Clutch lever shortened. (6.2.1g)

Exhaust slightly deteriorated (7.1.1a)

Front tyre is cracked

Rear Drive chain sprocket slightly worn (6.2.1e)

Clutch lever shortened. (6.2.1g)

Clutch lever shortened. (6.2.1g)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear reflector on motorcycle missing (1.4.1)

Front Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))