2004 Chrysler-jeep Crossfire

Dipswitch does not operate immediately when selected on main beam (4.1.3 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Inner Steering linkage ball joint ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Inner Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt tie rod (2.1.3 (g) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Front inner sidewall starting to split

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front tyre has slight damage to the outer sidewall

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

engine light on

nsf tyre side wall cut

Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Direction indicator has less than 50% of the light sources illuminating (1.4.A.2c)

Offside Rear Stop lamp not working (1.2.1b)

Rear Direction indicator has less than 50% of the light sources illuminating (1.4.A.2c)

Rear Tyre worn close to the legal limit (4.1.E.1)

Direction indicators not working (1.4.A.2c)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

NSF Tyre wall damage

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

NSF tyre wall damage

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)