1993 Talbot Express

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wing (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wing (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake load sensing valve linkage defective but function not impaired (1.1.17 (a))

Nearside Front Inner sill corroded

Nearside Front Inner sill corroded

Offside Headlamp aim too low (4.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Steering rack gaiter deteriorated (2.2.D.2d)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Ball joint has slight play (2.2.B.1f)

Offside Front Ball joint has slight play (2.2.B.1f)

plastic sill guards fitted preventing full inspection of sills

Offside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Bonded suspension unit deteriorated and cannot function as intended (2.4.F.3)

Brake pipe excessively corroded (3.6.B.2c)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Brake hose stretched (found during steering lock to lock check) (2.2.D.2b)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front brake disc excessively pitted (3.5.1h)

Nearside Headlamp aim too high (1.8)

Nearside Rear Shock absorber insecure (2.7.2b)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front brake disc excessively pitted (3.5.1h)

Offside Headlamp aim too low (1.8)

Offside Rear rear brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.C.1b) DANGEROUS