2000 BMW Z3

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emits clearly visible black smoke during acceleration (8.2.1.2 (g))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Windscreen washer not working (3.5 (a))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Brake inadequately mounted caliper spring missing (1.1.21 (c))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Rear Mechanical brake component locking device missing caliper securing spring (3.5.1l)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front coil spring broken (2.4.C.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced across an axle (3.7.B.5b)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too high and too far to the right. (1.8)

Power steering component(s) has slight seepage from a component (2.3.3b)

Power steering pump has slight seepage from a component (2.3.3b)

all brake discs slightly pitted

radiator weaping coolant

Offside Front Ball joint has slight play (2.2.B.1f)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Brake pipe slightly corroded (3.6.B.2c)

Front Exhaust system not adequately supported (7.1.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear brake disc excessively pitted (3.5.1h)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)