1993 Yamaha Xv

Nearside Rear All direction indicators not working nearside rear not working on arrival and was repaired on site. (4.4.1 (a) (ii))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Position lamp not working (4.2.1 (a))

Rear Stop lamp switch with a delay in operation light come on then goes out (4.3.2 (a) (ii))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Wheel has a slightly distorted bead rim. (4.2.2)

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Wheel has a slightly distorted bead rim. (4.2.2)

Front Wheel has a slightly eccentric bead rim. (4.2.2)

Headlamp aim too low (1.6)

Offside Steering control chaffing between components and not interfering with free movement of steering fouling fuel tank (2.1.2a)

Front Tyre worn close to the legal limit (4.1.3(ii))

Nearside Rear Direction indicator insecure (1.5.3b)

Registration plate insecure (6.3.1b)

Registration plate non-relective border too close to the characters (6.3.4h)

Steering control fouling between components which interferes with the free movement of the steering (2.1.2a)

Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars (2.1.2b)

Front Wheel damaged but not significantly reducing the original strength (4.2.1a)

Front Wheel damaged but not significantly reducing the original strength (4.2.1a)

Steering headbearing has slight free play (2.2.2)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Steering headbearing has slight free play (2.2.2)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Registration plate margin less than the minimum requirement (6.3.4g)

Registration plate with character(s) which are not the correct height (6.3.4a)

Registration plate with character(s) which are not the correct width (6.3.4a)

Steering headbearing has slight free play (2.2.2)

Front mudguard insecure (2.3.7)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Front Brake lever cannot be applied smoothly (3.1.3d)