1992 Mitsubishi 4X4

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Registration plate lamp likely to become detached (4.7.1 (c) (ii))

Offside Rear Anti-roll bar linkage damaged and seriously weakened (5.3.3 (b) (i))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

All position lamps slightly affected by the operation of another lamp hazzards (4.2.3 (c))

Tyre slightly damaged/cracking or perishing both front (5.2.3 (d) (ii))

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar linkage severely distorted (2.4.G.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Tyre has a tear, caused by separation or partial failure of its structure both front (4.1.D.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Centre Exhaust has a minor leak of exhaust gases outer skin corroded (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

evidence of fuel leak around pipe no leaks found during test but may require further attention soon

rear exhaust has been repaired using paste

Fuel system component leaking (7.2.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Oil leak

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

offside front tyre on legal limit

Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

offside/and/nearside/inner/cv/boots/split

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Front registration plate insecure (6.3.1b)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

fuel pipe corroded

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear brake disc slightly pitted (3.5.1h)