1992 Mazda MX-3

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen cracked not within drivers view

Exhaust system starting to rust

Both front tyre tread depths measure 3mm.

Inner-most edge of nearside rear tyre tread starting to distort.

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Small split in nearside wiper blade.

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front coil spring fractured (2.4.C.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Both front tyre tread depths measure 3mm.

Inner-most edge of nearside rear tyre tread starting to distort.

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front lower arm rear bushes becoming perished

oil leaking from both cam cover gaskets

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)