1991 Austin Mini Mayfair

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

slight corrosion to boot floor

Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Position lamp not working (4.2.1 (a) (ii))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

slight corrosion to boot floor

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Front floor corroded

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Wheel/tyre protruding beyond wheel arch ()

Hazard warning switch inoperative (4.4.2 (a) (ii))

Headlamp aim too high (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Front floor corroded

Offside Indicator tell-tale inoperative (4.9.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Wheel/tyre protruding beyond wheel arch ()

Front Exhaust system not adequately supported at gearbox mount (7.1.1)

Horn not working (1.6.2a)

Nearside Rear Subframe mounting prescribed area is excessively corroded front mounting area (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive rear of front subframe (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive both sections at mounting areas are corroding (2.4.A.3)

Subframe mounting prescribed area repaired, but not inappropriately rear subframe has been welded in several areas (2.4.A.3)

all rear areas are corroded around subframe mounts

Horn not working (1.6.2a)

Centre Front Upper Exhaust has a minor leak of exhaust gases (7.1.2)