1992 Talbot Express

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

both rear arches/side panels require attention.

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

corrosion to front inner wings/chassis

drivers seat slightly loose

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Position lamp not working (4.2.1 (a) (ii))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

corrosion to front inner wings/chassis

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement bushes cracked and perished on both suspension arms (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Horn not working (7.7 (a) (ii))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer sill (7.1.1 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Offside Front Electrical wiring for braking components extremely deteriorated (4.11 (b) (iii)) DANGEROUS

Coolant leak ()

Exhaust mounting defective (6.1.2 (a))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement bushes cracked and perished on both suspension arms (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive near spring hangers (5.3.6 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive near spring hangers (5.3.6 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Front wheel bearing has slight play (2.5.A.3c)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front wheel bearing has slight play (2.5.A.3c)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pipe excessively corroded to hub (3.6.B.2c)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear rear brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

N/S/R tyre has cut to side wall

O/S sill at at front corroded but not in prescribed area

O/S/R wheel arch corroded

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake pipe slightly corroded (3.6.B.2c)

Front brake disc slightly pitted (3.5.1h)

O/S/F sill inner and outter corroded not in prescribed area

O/S/R wheel arch slightly corroded

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear exhaust rubbers cracked and splitting

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear registration plate faded (6.3.1d)

Brake pipe slightly corroded (3.6.B.2c)

Front brake disc slightly pitted (3.5.1h)

O/S/F sill inner and outter corroded not in prescribed area

O/S/R wheel arch slightly corroded

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear exhaust rubbers cracked and splitting

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Exhaust system not adequately supported (7.1.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image kick up to the offside (1.8)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Exhaust mounting missing (7.1.1b)

Exhaust system not adequately supported (7.1.1)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Side repeater not working (1.4.A.2c)

Offside brake disc in such a condition that it is seriously weakened (3.5.1i)

Exhaust has a minor leak of exhaust gases (7.1.2)

brake disc slightly pitted (3.5.1h)