1995 Rover Mini

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Lower Seat belt anchorage prescribed area strength or continuity significantly reduced floor to sill areas (7.1.1 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Outer Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords on limts (5.2.3 (d) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Central Outer Seat belt anchorage prescribed area strength or continuity significantly reduced areas (7.1.1 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively os,ns (3.4 (b) (ii))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced areas (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area fractured significantly reducing structural strength subframe to mounting areas (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Service brake: efficiency below requirements (3.7.B.7)

front brake application uneven (3.7.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Electrical wiring deteriorated but not exposing bare wires (1.9.2c)

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear rear brake fluctuating, but not excessively (3.7.B.3)

Electrical wiring damaged, likely to cause a short (1.9.2b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear fog lamp not working (1.3.2b)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Electrical wiring deteriorated but not exposing bare wires (1.9.2c)

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear rear brake fluctuating, but not excessively (3.7.B.3)

non genuine exhaust fitted

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

non genuine exhaust fitted

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Rear Body has slight corrosion (6.1.B.2)

Offside Front Body has slight corrosion (6.1.B.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pipe slightly corroded (3.6.B.2c)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Outer Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Outer Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)