1992 Saab 9000 Cd

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front headlamp patterns slightly reduced

exhaust back box corroded

nearside front tyre worn on inner edge

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front headlamp patterns slightly reduced

exhaust back box corroded

nearside front tyre worn on inner edge

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Seat belt retracting mechanism defective (5.2.5b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp switch faulty (1.3.1a)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear exhaust box rusty,but not blowing yet

Nearside headlamp beam pattern is poor.

Petrol filler cap is broken, but still makes proper seal.

Plastic covers prevent full examinatiobn of outer body sills.

Rear brake disc pads APPEAR to be wearing thin.

Rear exhaust silencer is deteriorating.

Slight insecurity in mounting of front to rear metal brake pipe at main bulkhead.

Some movement in both rear anti-roll bar "D" mounting bushes.

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Nearside headlamp beam pattern is poor.

Petrol filler cap is broken, but still makes proper seal.

Plastic covers prevent full examinatiobn of outer body sills.

Rear brake disc pads APPEAR to be wearing thin.

Rear exhaust silencer is deteriorating.

Slight insecurity in mounting of front to rear metal brake pipe at main bulkhead.

Some movement in both rear anti-roll bar "D" mounting bushes.

Offside Front Brake hose slightly chafed (3.6.B.4d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

plastic covers on bodysills prevent a thorough examination

rear silencer deteriorated

some play in rear antiroll bar offside "D" rubber mounting

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Brake hose slightly chafed (3.6.B.4d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

plastic covers on bodysills prevent a thorough examination

rear silencer deteriorated

some play in rear antiroll bar offside "D" rubber mounting

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

both front wishbone rear most bushes have slight play.

Offside Outer Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

near side rear tyre outer wall has slight crackes

off side rear tyre outer wall has slight crackes