2010 Piaggio Xevo 400

Rear Dampers have slightly reduced damping effect.

Dipswitch does not operate immediately when selected on dipped beam (4.1.3 (b))

Headlamp aim not tested (4.1.2 (b))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Rear Dampers have slightly reduced damping effect.

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Brake lever has inadequate reserve travel (3.1.3b)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Hydraulic brake control creeps under load. (3.1.4a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Steering headbearing has excessive free play (2.2.2)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Steering movement excessively 'notchy' with the weight on the lower bearing (2.2.1a)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Headlamp aim too low (1.6)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Steering movement excessively 'notchy' with the weight on the lower bearing (2.2.1a)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

o/s/f headlight damage