2008 Kymco Super 8 125

Rear Brake lever is bent but brake can still be readily applied (3.1.3c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Wheel alignment slightly misaligned. (2.5.1)

exhaust mounting missing/defective - 1 bolt missing

front panelwork assembly loose

ignition switch faulty

rear brake lever operation stiff

speedo/meter defective

Front Floor brake test indicates a binding brake (3.3.C2c)

Headlamp aim too high (1.6)

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

1 of 2 exhausts mounts damaged/defective

Brake lever is bent but brake can still be readily applied (3.1.3c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Wheel alignment slightly misaligned. (2.5.1)

front panelwork assembly damaged/loose

ignition switch faulty

rear brake is stiff to operate

speedo/meter defective

front tyre perished

front tyre unevenly worn

Rear Brake lever pivots excessively worn (3.1.3a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

front tyre perished

front tyre unevenly worn

rear brake travel

Nearside Brake lever is bent but brake can still be readily applied (3.1.3c)

Headlamp aim beam image kick up to the offside (1.6)

Headlamp aim too low and too far to the right. (1.6)

Headlamp insecure (1.2.3b)

Nearside Brake lever is bent but brake can still be readily applied (3.1.3c)

handle bar cowling loose

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

nearside brake lever reserve travel

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Brake lever is short but brake can still be readily applied (3.1.3c)