2003 Mbk Ovetto

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Shock absorber has a reduced damping effect (5.3.2 (b))

Headlamp lens slightly defective Cloudy (4.1.1 (b) (i))

Headlamp reflector slightly defective (4.1.1 (b) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Front Shock absorber has a light misting of oil (5.3.2 (b))

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Stop lamp not working (4.3.1 (a) (ii))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Front Tyre worn close to the legal limit (4.1.3(i))

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Front wheel bearings are excessively rough (2.3.5b)

Front wheel bearings have excessive free play (2.3.5b)

Nearside Headlamp aim too low (1.6)

Offside Headlamp aim too high (1.6)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front Tyre worn close to the legal limit (4.1.3(i))

Front Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Headlamp aim too high (1.6)

Offside Front shock absorber has light misting of stanchion (2.3.3)

main stand does not return fully to its stop position.i have fitted an aid to keep the stand fully retracted.

Front Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Offside Front shock absorber has light misting of stanchion (2.3.3)

main stand does not return fully to its stop position.i have fitted an aid to keep the stand fully retracted.

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Nearside Front suspension assembly slightly corroded. (2.3.1)

Offside Front suspension assembly slightly corroded. (2.3.1)

Offside Front Front shock absorber has light misting of stanchion (2.3.3)

exhaust unit very rusty but not blowing at this moment in time.

oil low warning light on.

Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.2)

Rear reflector on motorcycle obscured (1.4.1)

exhaust unit very rusty but not blowing at this moment in time.

oil low warning light on.