1982 Rover Mini

Front Suspension arm pin or bush worn but not resulting in excessive movement both front tie bar bushes worn (5.3.4 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

can not check quality of welds due to underseal

front subframe bushes worn

rear brake quadrants part sized

rear exhaust rubber split

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Subframe mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Vehicle Identification Number not displayed (0.2 (a))

Front Brake pipe excessively corroded to rear (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Windscreen washer not working (3.5 (a))

Offside Front All direction indicators not working (4.4.1 (a) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Shock absorbers insecurely attached (5.3.2 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear fog lamp missing (4.5.1 (a) (ii))

Offside Windscreen washer not working (3.5 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))