2009 Kymco Agility

Front Position lamp not working (4.2.1 (a))

Front Tyre not fitted in accordance with side wall instructions On Backwards (5.2.3 (i))

Engine mounting/bracket bracket damaged but not to excess Worn Bushes (6.1.8 (a) (i))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Fuel Cap Seal Slightly Perished

Low Engine Oil

Rear Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Brake lever is bent but brake can still be readily applied Both (1.1.2 (d))

Rear Hugger Loose

Brake lever is bent but brake can still be readily applied both (1.1.2 (d))

Front Tyre worn close to the legal limit tyre on 2mm (5.2.3 (e))

Nearside Rear Shock absorber has a light misting of oil (5.3.2 (b))

Rear Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Front Front tyre starting to perish in tread

Front slight cut in tread

Nearside Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Rear Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Rear Shock absorber has a light misting of oil (5.3.2 (b))

Rear Fuel cap sealing washer slightly splitting on edge

Rear Rear brake caliper bushes worn

Rear Shock absorber has a reduced damping effect (5.3.2 (b))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Rear Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Rear petrol cap sealing washer starting to split

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Rear Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Rear petrol cap sealing washer starting to split