2006 Ktm 525SMR

Drive chain worn but not considered excessive (6.2.1e)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front wheel bearings are slightly rough (2.3.5b)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear Wheel spoke slightly loose. (4.2.1b)

Steering movement slightly stiff (2.2.1a)

all lights have been masked over or dis-connected,vehicle for use during daylight hours and not at times of reduced visability.

rear brake pads wearing uneven.

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Nearside Front wheel bearings have slight free play (2.3.5b)

Steering movement slightly stiff (2.2.1a)

all lights have been masked over, vehicle for use during daylight hours only and not at times of reduced visability.

front brake binding slightly.

front wheel rim has been repaired.

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front wheel bearings have excessive free play (2.3.5b)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Brake disc(s) excessively worn (3.2.A1l)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Wheel spoke missing (4.2.1b)

Rear wheel bearings have excessive free play (2.4.A.2c)

Steering headbearing has excessive free play (2.2.2)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Steering headbearing has slight free play (2.2.2)

front tyre worn uneven.

no indicators fitted at time of test.

Headlamp aim not tested (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Rear reflector on motorcycle missing (1.4.1)

Steering headbearing has slight free play (2.2.2)

front tyre worn uneven.

no indicators fitted at time of test.

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Front wheel bearings are slightly rough (2.3.5b)

Front wheel bearings have slight free play (2.3.5b)

Front wheel bearings have excessive free play (2.3.5b)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))