1990 Talbot Express

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced general corrosion. (6.1.1 (c) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength x2 (5.3.6 (a) (i))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength x2 (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Bumper likely to become detached (6.1.4 (a) (ii)) DANGEROUS

Integral body structure is corroded but structural rigidity is not significantly reduced General corrosion throughout (6.1.1 (c) (i))

corrosion n/s/r not prescribed area

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Headlamp insecure (4.1.1 (c))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheelarch (5.3.6 (a) (i))

Nearside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheelqarch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength behind shockabsorber (5.3.6 (a) (i))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheelarch (5.3.6 (a) (i))

Offside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheelarch (5.3.6 (a) (i))

Offside Front Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheelarch (5.3.6 (a) (i))

sill and outer sills getting weak and been welded outer body very rusty exhaust rusty

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside rear brake binding (3.7.B.1)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside rear brake binding (3.7.B.1)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Body has a sharp edge caused by corrosion front bumper at both sides (6.1.C.1)

Body has a sharp edge caused by corrosion front panel (6.1.C.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Battery insecure (1.9.1)

Nearside Front Body has a sharp edge caused by corrosion wing (6.1.C.1)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded crossmember (2.4.A.3)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Seat belt anchorage prescribed area is excessively corroded outer sill....... (5.2.6)

Nearside Side repeater not working (1.4.A.2c)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Subframe mounting prescribed area is excessively corroded inner wing......... (2.4.A.3)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Headlamp aim too low (1.8)

Offside Rear Body has a sharp edge caused by corrosion wheel arch....... (6.1.C.1)

Offside Rear Suspension spring mounting prescribed area is excessively corroded crossmember (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases joint (7.1.2)

Offside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear Registration plate lamp not working (1.1.C.1d)

Front Exhaust has a minor leak of exhaust gases joint (7.1.2)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front brake disc excessively pitted (3.5.1h)

Offside Front brake disc excessively pitted (3.5.1h)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake load sensing valve linkage seized (3.6.E.3)

nsr tyre side wall cracked slighty

Brake pipe slightly corroded (3.6.B.2c)