1991 Rover Vitesse

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

o/s/r floor pan has has corrosion, but outside 30cm of prescribed areas

All rear suspension components corroded, but not seriously weak

Engine oil leak, but not excessive

Front Brake pipe corroded, covered in grease or other material All front (1.1.11 (c))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced back panel (6.1.1 (c) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material All rear (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Crossmember mounting (5.3.6 (a) (i))

Nearside Rear Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Rear Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength X3 (5.3.6 (a) (i))

Rear Fuel pipe leaking (6.1.3 (b) (i))

All rear suspension components corroded, but not seriously weak

Engine oil leak, but not excessive

Front Brake pipe corroded, covered in grease or other material All front (1.1.11 (c))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced back panel (6.1.1 (c) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material All rear (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

o/s/r floor pan has has corrosion, but outside 30cm of prescribed areas

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Lower both lower ball joint dust covers covered in white grease

Nearside Front Lower steering rack gaiter has slight leak but not considered excessive

Nearside Front Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Inner brake disc heat shield loose but not likely to fall off

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Main beam tell-tale not working (4.9.1 (a) (ii))

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Nearside Rear Rear fog lamp adversely affected by the operation of another lamp (4.5.4 (b))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced front seat belt and rear seat belt anchorage point heavily corroded on inner sill (7.1.1 (a) (i))

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Lower both lower ball joint dust covers covered in white grease

Nearside Front Lower steering rack gaiter has slight leak but not considered excessive

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Inner brake disc heat shield loose but not likely to fall off

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Main beam tell-tale not working (4.9.1 (a) (ii))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear brake binding

Central Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Nearside Front Outer Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Outer brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear coil spring corroded (2.4.C.1b)

Nearside inner sill under sealed

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear inner sill corroded

Rear wheel arches corroded

Under sealing front to rear

all front and rear suspension components showinf varying degrees of corrosion.

front and rear prescribed areas showing varying degrees of corrosion.

long travel on parking brake lever.

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

n/s/f outer sill corroded.

n/s/f wheel arch corroded.

n/s/r tyre perished.

o/s/r wheel arch corroded.

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

n/s/f outer sill corroded.

n/s/f wheel arch corroded.

n/s/r tyre perished.

o/s/r wheel arch corroded.

Oil leak

front and rear brake pipes heavily greased.

front and rear suspension components showing varying degrees of surface corrosion.

n/s/r sill corroded.

Offside Headlamp aim too high (1.8)

Oil leak

Front Exhaust has a minor leak of exhaust gases (7.1.2)

N/s/r sill corroded

N/s/r sill protection fitted

Nearside Headlamp aim too high (1.8)

Various General areas of underseal

Front Exhaust has a minor leak of exhaust gases (7.1.2)

N/s/r sill corroded

N/s/r sill protection fitted

Oil leak

Various General areas of underseal

offside front metal brake pipe heavily greased

small exhaust leak at front

various areas with signs of corrosion

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Statutory seat belt missing (5.1.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

small exhaust leak at front

various areas with signs of corrosion

Nearside Front Headlamp aim too high (1.8)

Nearside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Headlamp aim too high (1.8)

Offside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

slight blow from exhaust manifold

slight seepage from power steering rack

Nearside Rear Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Brakes imbalanced across an axle (3.7.B.5b)