1993 Honda Civic Crx

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Obligatory mirror slightly loose interior mirror loose (3.3 (b) (i))

Oil leak, but not excessive Quite a mess under vehicle... (8.4.1 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Oil leak, but not excessive Quite a mess under vehicle... (8.4.1 (a) (i))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emissions likely to be affected by an induction leak holes in exhaust system (8.2.1.1 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm pin or bush excessively worn short arm (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn short arm (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge 'BALD' on inner edge..... (5.2.3 (e))

Front Service brake binding but not excessively (1.2.1 (f))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Front Service brake binding but not excessively (1.2.1 (f))

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Rear Brake pipe excessively corroded leaking (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

sill covers fitted

Emissions not tested (7.3.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Stop lamp not working (1.2.1b)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

sill covers fitted

Oil leak

sill covers fitted

Nearside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Oil leak

sill covers fitted

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

front brakes binding slightly

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

front brakes binding slightly

sill covers fitted ,suspect corrosion

Emissions not tested (7.0)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Trailing arm synthetic bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)