2000 Honda Cr-v

Brake performance not tested (3.7.A.1)

Brake pipe excessively corroded (3.6.B.2c)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Headlamp aim not tested (1.8.A.1c)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Anti-roll bar linkage insecure (2.4.G.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust system not adequately supported (7.1.1)

Rear Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear fog lamp not working (1.3.2b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front coil spring incomplete (2.4.C.1a) DANGEROUS

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

corrosion at floors, floors to sills,rear floors,front and rear inner arches,rear boot floors and sill backs

heavy corrosion on exhaust

initial play in offside top ball joint

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

initial play in offside top ball joint

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Lower Ball joint has excessive play (2.2.B.1f)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Lower Ball joint has excessive play (2.2.B.1f)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)