2012 Ssangyong Rexton

Nearside Front Suspension arm ball joint excessively worn Upper arm. Outer ball joint. (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front brake pads over half worn, brakes discs slight wear.

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Tyre worn close to legal limit/worn on edge o/s&n/s and perishing 235/75/16 (5.2.3 (e))

offside and nearside rear chassis rails corroded

Front Headlamp aim too high o/s&n/s (4.1.2 (a))

Front brake pads over half worn, brakes discs slight wear.

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Tyre worn close to legal limit/worn on edge o/s&n/s and perishing 235/75/16 (5.2.3 (e))

offside and nearside rear chassis rails corroded

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Power steering component has slight seepage from a component Rack (2.1.5 (a))

Rear Passenger seat(s) missing at time of test 3rd row ()

Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis corroded (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Power steering component has slight seepage from a component Rack (2.1.5 (a))

Rear Passenger seat(s) missing at time of test 3rd row ()

Rear fog lamp not working Tow bar electrics adapter removed. (4.5.1 (a) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis corroded (6.1.1 (c) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement perished (5.3.4 (a) (i))

Offside Rear Parking (secondary brake) grabbing slightly efficiency very low (1.3.1 (c))

bump stops damaged

Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement perished (5.3.4 (a) (i))

Offside Rear Parking (secondary brake) grabbing slightly efficiency very low (1.3.1 (c))

bump stops damaged

Nearside Rear Rear reflector slightly damaged but function not impaired (1.5.1c)

stone chips on front screen

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Windscreen wiper does not clear the windscreen effectively blade split (8.2.2)

Offside Rear Mechanical brake component has restricted free movement handbrake not holding (3.5.1k)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Rear reflector slightly damaged but function not impaired (1.5.1c)

Offside Front Front position lamp(s) deteriorated, but still visible from a reasonable distance sidelight bulb (1.1.A.3d)

Offside Front Outer Brake pad(s) wearing thin (3.5.1g)

stone chips on front screen

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

All 4 tyres on 3mm

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)