2009 Fiat Doblo Cargo

All position lamps not working Suspect switch fault (4.2.1 (a))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Outer Brake pad(s) less than 1.5 mm thick Pad in metal to metal contact with disc. (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust system heat shield partially insecure.

Offside Front Tyre wearing excessively on inner edge.

Offside Rear Nail in tyre ()

Oil leak, but not excessive (8.4.1 (a) (i))

Central Stop lamp not working (1.2.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high and pattern (1.8)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Exhaust has a major leak of exhaust gases box (7.1.2)

Exhaust has a minor leak of exhaust gases rear box (7.1.2)

Offside Rear tyre slightly misshaped

all steering and suspension heavily corroded

engine management light illuminated

front brake disks worn and corroded

oil leak

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Road wheel distorted (4.2.A.1a)

Offside Front Front drive shaft support bearing excessively worn (2.5.C.2c)

Windscreen wiper does not clear the windscreen effectively both front (8.2.2)

Exhaust has a minor leak of exhaust gases rear box (7.1.2)

Offside Rear tyre slightly misshaped

all steering and suspension heavily corroded

coolant level low

engine management light illuminated

front brake disks worn and corroded

oil leak

Exhaust emits an excessive level of metered smoke (7.4.B.3a)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

both front top suspension mounts unbonded.osr tyre low and perished.

rear foot brake performance low

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

both front top suspension mounts unbonded.osr tyre low and perished.

rear foot brake performance low