1990 Suzuki GS125

Drive chain excessively tight (6.2.1d)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Rear Motorcycle structure excessively damaged swinging arm (6.1.1a) DANGEROUS

Exhaust is leaking but is not excessively noisey (7.1.1b)

Steering movement slightly stiff (2.2.1b)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Registration plate delaminated (6.3.1.d)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Brake disc(s) has slight run out (3.2.A1m)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Wheel has a slightly distorted bead rim. (4.2.2)

Wheel alignment slightly misaligned. (2.5.1)

front tyre has slightly perished

Horn not working (1.7.3a)

Fuel cap sealing washer torn (7.2.2c)

Rear reflector on motorcycle obscured (1.4.1)

Front Brake disc(s) has slight run out (3.2.A1m)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Wheel has a slightly distorted bead rim. (4.2.2)

Wheel alignment slightly misaligned. (2.5.1)

front tyre has slightly perished

Front Brake disc(s) has slight run out (3.2.A1m)

Headlamp aim too low (1.6)

Oil leak

Rear reflector on motorcycle obscured (1.4.1)

Wheel alignment slightly misaligned. (2.5.1)

front tyre is slightly perished

fuel cap seal is slightly perished

registration plate is starting to delaminate

Front Brake disc(s) has slight run out (3.2.A1m)

Oil leak

Wheel alignment slightly misaligned. (2.5.1)

front tyre is slightly perished

fuel cap seal is slightly perished

registration plate is starting to delaminate

Front Brake disc(s) has slight run out (3.2.A1m)

Front Brake disc(s) slightly worn (3.2.A1l)

Front wheel bearings are slightly rough (2.3.5b)

Rear Wheel has a slightly distorted bead rim. (4.2.2)

Steering movement slightly stiff (2.2.1a)

number plate slightly faded

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Steering movement excessively 'notchy' with the weight on the lower bearing (2.2.1a)

Front Brake disc(s) has slight run out (3.2.A1m)

Front Brake disc(s) slightly worn (3.2.A1l)

Front wheel bearings are slightly rough (2.3.5b)

Rear Wheel has a slightly distorted bead rim. (4.2.2)

number plate slightly faded

Front Brake disc(s) friction surface contaminated by oil or grease (3.2.A1k)

Front Brake pad(s) contaminated by oil or grease (3.2.A1k)

Front Clutch lever shortened so it cannot be readily operated. (6.2.1g)

Front Direction indicator insecure (1.5.3b)

Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Brake pedal has inadequate reserve travel (3.1.3b)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Steering movement slightly 'notchy' (2.2.1a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front suspension has inadequate damping effect. (2.3.6c)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Headlamp dipped beam affected by the operation of another lamp (1.2.2c)

Steering headbearing has excessive free play (2.2.2)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))