1990 Talbot Express

All direction indicators not working (4.4.1 (a) (ii))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Indicator switch inoperative (4.4.2 (a) (ii))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis/inner wing (6.1.1 (c) (i))

Nearside Front Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength end wheel arch (5.3.6 (a) (i))

Nearside Rear Outer Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Upper Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Inner Suspension spring mounting prescribed area is inadequately repaired wheel arch (5.3.6 (a) (i))

Offside Rear Outer Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen wiper not working (3.4 (a))

Exhaust mounting defective (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive wheel arch (5.3.6 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced chassis (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

heavily undersealed underside

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

bonnet rusty

rusty underside

wheel trims

Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wings both (5.3.6 (a) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced under sills (7.1.1 (a) (i))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

bonnet rusty

rusty underside

wheel trims

rusty underside

wheel trims

Front Inner wings rusty

Inner Suspension component mounting prescribed area is corroded but not considered excessive under sills (5.3.6 (a) (i))

Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

wheel trims

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

various signs of light corrosion to vehicle under side

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Front Suspension component mounting prescribed area is excessively corroded crossmember (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Rear Suspension component mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Brake pipe slightly corroded front to rear (3.6.B.2c)

Nearside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Direction indicator not working (1.4.A.2c)

Offside Front drive shaft support bearing excessively worn (2.5.C.2c)

Registration plate lamp not working (1.1.C.1d)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

n/s/r tyre perished

slight play o/s/f wheel bearing

underside of vehicle corroded

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

n/s/r tyre perished

slight play o/s/f wheel bearing

underside of vehicle corroded

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too high (1.8)

Nearside and Offside front sills Have slight corrosion

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Exhaust engine idle speed too high (7.3.A.2a)

Nearside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Braking system leaking (3.6.A.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)