2002 Yamaha Serow

Front Brake binding but not excessively (1.2.1 (f))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement SWING ARM (5.3.4 (a) (i))

Rear Drive chain sprocket worn to excess (6.1.7 (c) (i))

Rear Drive chain worn to excess (6.1.7 (c) (i))

Rear Drive chain slightly loose (6.1.7 (c) (i))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement SWING ARM (5.3.4 (a) (i))

Brake pivot has restricted free movement (1.1.15 (e))

Rear reflector missing (4.8.2 (a) (ii))

Front Brake lever has inadequate reserve travel lever adjusting screw was fouling throttle body (3.1.3b)

Offside Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Rear brake readjusted to compensate for suspected worn linings .advise -change linings as soon as possible.

Centre Fuel system component leaking (7.2.1a)

Front Roller brake test indicates a sticking brake (3.3.A1a)

Offside Front Direction indicators not working (1.5.1c)

Rear Wheel spoke excessively loose (4.2.1b)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i))

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.2)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Nearside Clutch lever positioned so it cannot be readily operated. (6.2.1g)

Rear Chain guard fouling another component (6.2.1c)

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))