1989 Talbot Express

All direction indicators not working (4.4.1 (a) (ii))

Front Windscreen wiper not working (3.4 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Rear Brake hose damaged and likely to fail Split and leaking (1.1.12 (a)) DANGEROUS

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Front Fluid leak harmful to the environment or a risk to other road users Petrol (8.4.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust system insecure (6.1.2 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Exhaust fumes causing a danger to health of persons on board (6.1.2 (b) (ii))

Body has slight corrosion many areas have been repaired (6.1.B.2)

Gearbox mounting defective

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Valve stem slightly damaged (4.1.D.1e)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Headlamp insecure (1.7.3)

Brake pedal spongy (3.3.B.1b)

Emissions not tested (7.3.A.1)

Exhaust engine idle speed too high (7.3.A.2a)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Exhaust system not adequately supported (7.1.1) DANGEROUS

Body has slight corrosion many areas have been repaired (6.1.B.2)

Gearbox mounting defective

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Valve stem slightly damaged (4.1.D.1e)

Offside Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

front Exhaust has a minor leak of exhaust gases (7.1.2)

front exhaust clamp loose

lower windscreen scuttle panel corroded

nearside sill has been repaired

offside Rear wheel bearing has slight play (2.6.2)

offside front door corroded

offside front rubber tyre valve perished

offside front sill has been repaired

offside rear brake fluctuating, but not excessively (3.7.B.3)

offside rear outer sill corroded

offside rear wheel arch corroded

offside rear wheel arch has been repaired

rear doors corroded

rear gear box rubber mount worn

small crack in first exhaust silencer

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded sill area (2.4.A.3)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Rear Registration plate lamp not working (1.1.C.1d)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)

Nearside sill has been repaired

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front door corroded

Offside Front rubber tyre valve perished

Offside Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive outer sill area (2.4.A.3)

Offside Rear outer sill corroded

Offside Rear wheel arch corroded

Offside Rear wheel arch has been repaired

Offside Rear wheel bearing has slight play (2.6.2)

Offside rear brake fluctuating, but not excessively (3.7.B.3)

front exhaust clamp loose

lower windscreen scuttle panel corroded

offside front sill has been repaired

rear doors corroded

rear gear box rubber mount worn

small crack in first exhaust silencer

Front Exhaust noisy (7.1.4)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

battery not clamped down properly

corrosion to nearside rear outer sill

slight movement to offside headlight unit

Body has slight corrosion (6.1.B.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

exhaust rubber mount worn or missing, exhaust is secure

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Body has slight corrosion (6.1.B.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

exhaust rubber mount worn or missing, exhaust is secure

Body has slight corrosion (6.1.B.2)

small cut within n/s/f lower ball joint gaiter

some movement within o/s/f strut top mount

some movement within o/s/f wheel bearing

Front Driver's seat cannot be secured in the upright position. (6.2.A.2)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front brake imbalance high

small cut within n/s/f lower ball joint gaiter

some movement within o/s/f strut top mount

some movement within o/s/f wheel bearing

Body has slight corrosion (6.1.B.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

damage to offside headlamp

front and rear bumpers corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

advise all rubber bushes cracking

exhaust rubbers cracking

o/s/f head light has bad earth bot ok at the time off test

rust to both rear quarters panels

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Front wheel bearing has slight play (2.5.A.3c)

Front wheel bearing has slight play (2.5.A.3c)

rubber exhaust mountings perished

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front brake disc excessively pitted (3.5.1h)

Nearside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front brake disc excessively pitted (3.5.1h)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front wheel bearing has slight play (2.5.A.3c)

rubber exhaust mountings perished

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Front wheel bearing has slight play (2.5.A.3c)

nearside rear valance corroded

Hazard warning switch faulty (1.4.B.1d)

Horn not working (1.6.2a)

Centre Registration plate lamp not working (1.1.5c)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust mounting missing (7.1.1b)

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Nearside Rear wheel bearing has excessive play (2.6.2)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Rear wheel bearing has excessive play (2.6.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Front wheel bearing has slight play (2.5.A.3c)

nearside rear valance corroded

right turn indicator tell tale not working correctly

Front Exhaust has a minor leak of exhaust gases (7.1.2)